Just Might DIY

While Roadie may not be as tall as most dogs, we still wanted to raise his bowls up just a bit to make eating and drinking a bit more comfortable. Enter, the Plywood Pattern Dog Bowl Stand. 

Designed to lift the bowls off the ground to give dogs a better eating and drinking position, dog bowl stands also help hold the bowls in place so your pup doesn’t chase them around while they’re scarfing down their food. Plus, they add a nice decorative element to something that otherwise looks a bit messy. 

We designed this one to coordinate with the Dog Butt Leash Organizer we made when we first adopted this energetic ball of hair.

However, rather than going with the herringbone plywood pattern again, we decided to switch it up slightly and go with a chevron plywood pattern.

It’s similar enough to coordinate but not be matchy matchy. 

See how we made this Chevron Plywood Pattern Dog Bowl Stand Below:

🛒 Tools and Materials (most links = affiliate links):

Plywood
Table or circular saw – https://amzn.to/3bCH4jK
Random orbital sander – https://amzn.to/37q46ca
Miter saw – https://amzn.to/2YDSAGw
Jig saw – https://amzn.to/2JMTgpQ
Black stain – https://amzn.to/2LHjfwF
Tung oil – https://amzn.to/36bq42L
Wood glue – https://amzn.to/3cKrJ1U
Super glue – https://amzn.to/2AyK6Zk
Measuring tape – https://amzn.to/3bKyTSz
Pencil – https://amzn.to/2WKMfKm
Drill – https://amzn.to/2GiNK9g
Bar clamps (we got ours at Harbor Freight, but these are similar) – https://amzn.to/3mN1SeC
Stainable wood filler – https://amzn.to/3gctrM9
Polyurethane – https://amzn.to/2XtZXAz
Cricut Maker: https://cricut.pxf.io/maker

If you prefer written instructions…

If you prefer to follow along with written instructions, we have the solution for you!

Check out our Instructable, which has written steps and photos:

Plywood Pattern Dog Bowl Stand!

And if you liked this post, pin the graphic below!